This sets the BIOS to intervene and make the actual SATA device appear to the OS (Win XP) as a plain old IDE device which it DOES know how to use without added drivers. Go to where the SATA ports are configured, and look for a line about SATA Port Mode. IF you intend to boot from the CD unit, you can try the work-around built into most mobos for the combination of XP and SATA. Of course, if this works, one way to re-arrange is to have your CD back on the IDE port, and the Zip drive on the SATA adapter, since you're more likely to want to boot from the optical drive than from the Zip drive.ΔΆ. That is because Win XP MUST boot from some non-SATA device first, and in the process access the boot device to load the SATA device Driver before it can use that unit. The LIMIT of this is that you cannot BOOT from this device. Then you can set the SATA Port Mode to SATA or AHCI and use whatever device is connected there as a SATA device. In this way XP can learn how to use a SATA device. That should be on the CD that came with your mobo. IF you intend to use the adapted device (in this case, the CD unit) ONLY for reading and writing AFTER Win XP has loaded, you need to install in XP (while it is running) the SATA port device driver for your mobo. So, assuming your adapter makes the IDE optical unit appear to be a valid SATA device, the BIOS will recognize it (you say it does), but XP will NOT. XP does NOT have "built-in" knowledge (a driver) of SATA devices. Find someone with IT experience to get your solution going if you don't follow mine, but mine is simple.Check again jitpublisher's point. It would probably have worked on Windows 10 as well, but my Windows 10 desktop does not have an EIDE connector so I was forced to acquire the adapter spoken of. This page has a lot of drivers for the USB Zip drives, and I tried one of them on a Windows 98 Second Edition retrobox and it worked with the ATAPI Zip 250 connected directly to the motherboard's EIDE connector (no adapter required). No software 'should' be required as the PCI-to-EIDE adapter will operate the ATAPI Zip drive from the auspices of its own SCSI driver. Once you get that hooked up in Windows you will have access to your drive and Zip disks without any additional software. I got mine locally from a local used computer parts dealer: Purchase an ATAPI Zip 250 drive from a junk peddler on eBay. Purchase a PCI (or PCIe)-to-EIDE adapter for desktop computers. I also learned from this forum that there are no driver updates beyond Windows XP. Just plugging in the USB cable activates the drive. I was able to just plug in my Iomega 250 Zip Drive and download my date. I did learn through a forum that driver software is not required for the USB supported Zip Drives. I would advise anyone against subscribing to Driver Navigator. I will have to go to PayPal and get them to arbitrate. I have told them why I do not wish to continue use of their software and they keep trying to get me to keep it. Driver Navigator is continuing to try to get me to keep the software and is not wanting to refund my money, even though they state a 60 day 100 percent refund if not satisfied. Driver Navigator refunded my money immediately, without question. After subscribing to Driver Navigator and Driver Update, I learned this was not true. It gave the appearance that they could provide Iomega Zip Drive support. I went to the referenced address and found several companies offering help with downloading drivers.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |